CNC priedėlio pagalba lengvai galėsite valdyti 4 žingsninius variklius. CNC priedėliai naudojami lazeriniams pjaustyklėms, graviravimo, piešimo mašinoms ar kitiems projektams konstruoti. 

CNC priedėlis:

• Spalva: Raudona
  
• Dydis(L*W*H):68 x 53 x 18 mm
• Įtampa: DC 12~36 V (At the moment only the DRV8825 drivers can
• handle up to 36V so please consider the operation voltage when powering the board.)

Features:

• 1.Uses removable A4988 or DRV8825 compatible stepper drivers.
• 2.The extension board can be used for carving machine,
• 3 d printer driver expansion board
• 3.GRBL 0.8 compatible. (Open source firmware that runs on an
• for arduino UNO that turns G-code commands into stepper signals)
• 4.PWM Spindle and direction pins,4-Axis support
• (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
• 5.Compact design. Stepper Motors can be connected with 4 pin molex connectors or soldered in place.
• 6.Please note that this is an unassembled kit and Basic soldering skills are needed.

(2)A4988 Stepper Motor Driver

• Color:Red
• Size(L*W*H):20 x 15 x 10 mm
• Thermal shutdown circuitry:Yes
• Crossover-current protection:Yes
• Ground fault protection:Yes
• Load short-circuit protection:Yes
• Compatible logic supply: 3.3V and 5 V
• Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16

Features:

• 1.Mix with slow current decay modes.
• 2.Internal UVLO and Low RDS (On) Output.
• 3.Automatic current decay mode detection/selection.
• 4.Synchronous rectification for low power dissipation.
• 5.Warning: Connecting or disconnecting a stepper motor while the driver is powered can destroy the driver.

Komplektą sudaro:

1 x CNC priedėlis

4 x A4988 žingsninių variklių valdikliai su aušintuvais